Steps For Sharpening Pruners Gardening Tool


Steps For Sharpening Pruners Gardening Tool

If you are a serious gardener, then you must have a proper set of tools. Hand pruner is one of the essential tools for maintaining your garden. It allows you to cut the sturdy branches of trees and shrubs. Thus, you can use it for pruning the deadwood that can cause harm to the plant. It is essential to maintain your pruner in good condition. The one with proper sharpness will provide cleaner cuts to keep the plant in a healthy state. In this article, we describe steps for sharpening pruners gardening tool. Therefore, you must read this article very attentively until the end.

Steps For Sharpening Pruners Gardening Tool
Steps For Sharpening Pruners Gardening Tool

Supplies Required For Sharpening Pruners Gardening Tool

  • Kitchen scouring pad
  • Clean rag and towel
  • Gloves
  • Steel wool (fine)
  • Soap and warm water
  • Steel wool (semi coarse)
  • A dry or silicone-based lubricant (such as White Lightning)
  • Diamond files (coarse, fine, and extra-fine)
  • Twigs to test your progress

Steps To Follow For Sharpening Pruners Gardening Tool

First of all, you need to keep one thing in mind. Sharpening the blades of this tool is not rocket science. It demands patience as well as practice. Hence, you need to follow the below steps very correctly to get the best results:

Start With A Good Cleaning

The first step that you need to take is to clean your pruner. If the cutting surface of this tool has a grim on it, it cannot cut properly, even if it is sharp.  Hence, it is essential to clean it appropriately. Take a scouring pad and little warm water. Add the soap in it and scrub it. Clean all the plant bits, or other gunk presents on it. Wipe the blades dry.

Steps For Sharpening Pruners Gardening Tool
Steps For Sharpening Pruners Gardening Tool

For removing the rust, you need to use the coarse steel wool. It also helps you to remove any tough matter present on the blades. Now, you need to use the finer steel wools for restoring the metal’s sheen.

Get The Angle And Motion Right

First of all, wear gloves for safety. Start with the file, which is the most coarse. Then, move on the finest ones for the edges of your tool. Before using anything, pat the blades with a moist cloth. It will help to prevent the file from clogging due to tiny particles of metal that will shed from edges. Hold the pruner in your hands. Now, take the file between 10 to 20 degrees as compared to the blades. You need to begin with the inside of the pruner blade. Then, draw it towards the tip in a curved motion according to its shape. It will sharpen the blade evenly and safely. If you regularly maintain your pruner, then 10 to 20 draws are sufficient. However, you need to pass it for about 40-50 times in a poorly maintained tool.

For sharpening the edges, switch to the finer grits. Use the same number of passes with each file from fine to extra-fine. Remove the burrs using the extra-fine file a few times over the backside.

Finish With Lubricant

After that, test the sharpness of the blade using the twigs. If you get satisfied, then apply a dry or silicone-based lubricant on the blade. It will help to repel water for hindering oxidation and rust.

Subscribe to our monthly Newsletter
Subscribe to our monthly Newsletter